Hey, I'm Brian from Egypt travel Vans. And today we're going to be talking about a few things
that you'll need to look at with the switch panels on your Firefly system.
So what we're going to look at now is also replacing the batteries one
thing that can happen. Of course, these are all battery-powered switches
and they've got a little button cell battery on the
back of them that needs to be replaced when they do get low. So if you find that one of
your screens has not been paired properly or if it's not responding we
can go into settings and you'll see switch panel
in full we'll go over to that and at this point you can
see if any of the panels are not paired. And if you're
looking at the floor plan here, you can see that there's a one two three four one
corresponds to which one it is. If there's a dead battery, you
may see that this battery symbol right here would turn red with
probably an x on it or something, but it'll show you that the battery is
getting low and it's time to be replaced. So in order to replace them in
a case like this one here in the entrance, you'll have to pop this panel off.
So if you just grab it on the side.
You can pop it off on the side. You can see that there's a couple
little Clips holding it in place.
Once you have it off, this is where you're going to see the little
button cell battery. It's hidden right in here. So here we've got
the Button cell battery. We're gonna pull it out. This is a CR2032 3
volt battery. So you have to get a new
one of these and it's pretty simple to replace it. You're just gonna take the battery slide it
back in place making sure that the positive is up. You can see that there's
a positive indicator there as well. So just make sure positive is up slide it
in place like that and the batteries replaced the
clip it back in just pretty simple.
line it up and
make sure all four corners are clipped in place. So some of the
switch panels you can see are also a flush mount like this. So in order to access the
battery, there are some access points in behind there. So if you reach
in behind there, you can actually pop that panel off.
Once the panel's off again you can access the battery.
At this point because you replace the battery. You may need to
pair the switch again with LCD panel. We can go into
settings and you'll see switch panel in full
we'll go over to that and at this point you can see if any of
the panels are not paired. In this case. You can see that
they are all nicely paired. You've got good signal strength on each
one and then it also shows that the battery power is good
on each one as well. And if you're looking at the floor plan here, you
can see that there's a one two three four one corresponds to
which one it is. And this also showing that they're paired properly. So
it just helps you figure out which ones are not pair properly that need to
be paired again and again to pair this switch Press On
the entry
and we'll hit start pairing.
So you've got about 30 seconds in order to pair the the panel
in order to pair the panel. You're just going to press and hold any two
buttons.
And you should see it on the screen. It'll pop up that it has been paired.
The pairing is successful and you can press done.
And you'll see that now it has gone from a white to
a green so it's showing you that the signal strength is good. So
you'll see that it also still shows that it is in Red. So
the entry is in red it is picking it up, but it may take a little
while for this to turn green as well, but it will happen after a few minutes and
you should see that actually turn back to green as well at this
point. You can also test the function of it you can
Make sure everything is actually working properly and you can see that this switch is
now paired properly again.