Use these steps for the Leisure Travel Vans Unity or Wonder. The procedure is demonstrated on a Unity; the same principle applies to a Wonder.
Check whether the pump shaft is stuck
Loosen the two Phillips screws enough to pivot the cover out of the way. Do not remove the screws completely.- Use a flat-blade screwdriver to turn the end of the pump shaft. Turning the shaft may free an impeller that is stuck. If the shaft turns freely, the problem may be elsewhere.
Remove the macerator pump
You’ll need side cutters to cut the wire ties and a flat-blade screwdriver or 5/16 nut driver to loosen the clamps. A knife can also cut the ties.
- Cut the wire ties holding the pump wires. Cut any additional tie you find near the connector, then peel back the wire loom to reach it.
- Pull the connector tab and unplug the electrical connector.
- Wear gloves before removing the hose. Loosen the clamp holding the hose to the pump, then pull the hose off. Some liquid may spill. Push the hose up into the compartment.
- Make sure the gate valves are closed before removing the pump.
- Loosen the gear clamp supporting the back of the pump.
- Turn the pump about one-quarter turn or one-eighth turn counterclockwise to release it from the bayonet fitting, then remove it.
Connect the gravity drain hose
Get the 3-inch gravity drain hose from its storage compartment.- Fit the hose connector onto the drain tabs and turn it to lock it in place.
- Dump the black tank first, then the gray tank.






