Leisure Travel Vans places the inverter in different locations depending on the coach. It may be in an exterior compartment or inside under the bed. The inverter remote is inside the coach.
Wake the remote and read the display

- Press OK to wake the remote if its display is blank.
- Check the status shown on the display. Bypass Mode means shore power is connected and passing through to the receptacles on the inverted circuit. The inverter can also charge the batteries while shore power is connected.
- When shore power is disconnected, the display will no longer show Bypass Mode.
Open and change inverter settings

These settings are factory-set. You generally do not need to change them unless you change the inverter or batteries. Settings vary by battery type and manufacturer.
- Press and hold OK until the settings screen appears.
- Use the Up Arrow to scroll through the settings.
- When the setting you need is displayed, press OK to select it.
- Use the Up Arrow to change the selected setting.
- Press OK to save the setting, then press Escape to leave the settings screen.
Some settings may not appear, depending on the battery-type selections. Do not change factory-set values unless you know the settings required for your inverter and battery configuration.
Avoid the full factory reset
Setting 99 is a full factory reset. Pressing and holding OK on that setting resets the inverter to the inverter manufacturer’s factory settings, not the settings preset by Leisure Travel Vans. This reset is not normally required.
Battery disconnect and inverter operation
The battery disconnect switch must be on to use the inverter’s invert function. Turning the switch off shuts down the inverter and stops it from powering the inverted circuits. If you are connected only to shore power, the inverter can still convert power and charge the batteries with the battery disconnect switch off.






