On your Leisure Travel Vans entrance door, you can check whether the keyless entry sends power to the lock by testing the contact points and, if needed, the wiring inside the door.
Test the door contact points
- Gather a Phillips screwdriver and a 12-volt test light or voltmeter.
- Place the test leads on the two contact points for the keyless entry.
- Press the lock and unlock buttons. With a voltmeter, set it to DC volts first. The power pulse lasts about a second, and its polarity reverses between locking and unlocking. You should not expect constant power at the contacts.
Clean dirty or corroded contacts
- If the contact points are dirty or corroded, clean them with Scotch-Brite or light sandpaper.
- Apply a light coating of lubricant to the terminals, then test the contacts again.
Check the deadbolt at the door
Close the door only far enough for the contact points to touch while you can still see the deadbolt.- Press lock and unlock, and check whether the deadbolt moves. If it does not move, inspect the wiring and actuator inside the door.
Inspect wiring inside the door
Use a Phillips screwdriver to loosen the cover-plate screws, remove the two screws, and slide the plate out.- Note how the wires are connected before you disconnect them. The wire colours can vary.
- Pull apart the push connectors to separate the wires coming from the door contacts from the wires going to the actuator.
- Close the door so the outside contact points touch. Test the two terminals on the wires coming from the door contacts—not the disconnected actuator wires. Press lock and unlock to check for a power pulse. Polarity does not matter for this check.






